STM32 ST-LINK Utility.exe is the programs's main file and it takes around 604.50 KB (619008 bytes) on disk. STM32 ST-LINK Utility installs the following the executables on your PC, occupying about 2.61 MB ( 2741632 bytes) on disk. STM32 ST-LINK Utility's primary file takes about 300.00 KB (307200 bytes) and is named STM32 ST-LINK Utility.exe. /android-pie-download-for-lg-v40-thinq-sprint-unlocked.html. STM32 ST-LINK Utility is comprised of the following executables which occupy 876.50 KB ( 897536 bytes) on disk. Download the ST Link Utility from here, and download the firmware file from the project files list. Connect the J3 pins to either another ST-Link, or the ST-Link part of a discovery board. There are also ways to flash the firmware using other dev boards, and USB-UART modules, however I won't go into that here, there is ample info already out there.

1. Stm8 St Link Utility Download
2. Stm32 St-link Utility V4.3 Download

Stm8 St Link Utility Download

As you may know, ST also produces his own debugger/programmer called ST-Link. It supports JTAG and SWD interfaces. You can purchase an ST-Link USB adapter, but there is a better option if you are into STM32 microcontrollers, and probably own one of ST32 Discovery boards. Since I have STM32VLDiscovery nearby, this is how to program another STM32F103RBT6 board using only four wires.

On discovery board, locate CN3 jumpers and disconnect them as they connect discovery board to a debugger.

Then locate CN2 pins and connect them to target boards JTAG connector as follows:

• VDD (pin 1) to JTAG VCC (pin 1)
  
• SWCLK (pin 2) to JTCK (pin 9)
  
• SWDIO (pin 4) to JTMS (pin 7)
  
• GND (pin 3) to GND (pin 4)
  

Power both boards and open ST-Link utility. You can see that the Medium Density board has been detected.

Now you can load the binary file, and program microcontrollers Flash memory. Using the Target menu, you can perform additional operations similar to J-Flash.

An exciting feature of ST-Link is MCU panel. Here you can do various things like Run code, halt, step, reset, core reset, and read core registers. You can treat this panel as a quick debugger

You will find a great tutorial in the user manual in ST-Link install location on your PC.

A couple more flashing methods: embedded bootloader and Using J-Link JTAG adapter

Stm32 St-link Utility V4.3 Download

This guide is targeting Linux users and ST-Link v2 hardware.

First, we are going to install the necessary libraries and build tools:

Now, we will download and build the ST-Link utilities:

/how-to-download-sketchfab-models.html. Now we copy the built binaries to their place:

then udev rules:

Now, plug the ST-Link device into the USB port, but DON’T CONNECT the target board, then type:

If everything went OK, you should see something like this:

then:

Now, disconnect the ST-LINK from USB, connect the four wires to the target board as in the picture

then plug back the ST-Link to the USB and type:

You should see something like:

If the target board is not connected, the ST-Link device will be identified, but you (obviously) will get an error during memory read.

We can decide it is correctly installed.

Please add comments if you encounter any issue using this guide. I hope it will help you.

Thanks for the effort to all contributors to this repository https://github.com/stlink-org/stlink .

Check these articles related to STM32.

The older version of this post is here.